Royal 220DX - Receipt ON;OFF; Post Sale Change Calculation

50
8.17 Receipt ON/OFF
There are 2 ways for this operation
1. The first way
Use the [RCPT /OFF] key, it can act on any mode; user also can press it at any
moment except during the transaction and programming the descriptors.
Set the Bit A to “0” in Terminal Status 13 in System Option Preset, then the
clerk key function will change to [RCPT /OFF] key
2. The second way
Set the Bit B to “0” in Terminal Status 3 in System Option Preset, then the
receipt will stop printing.
The far right digit will be lit when the receipt is on OFF status.
8.18 Post sale change calculation
After finalizing a transaction paid by cash, the change due is shown on the display. If
you need to review the change amount: (Enter cash amount) [TOTAL]
The display will review the cash change.
Note:
It must be out of a transaction and the amount of the tender entered cannot less than
the amount purchased.
This operation can also be used for closing a table temporarily in the Restaurant
Mode.