Royal 220DX - PLU Group Programming; System Option Preset

21
7.3.3 PLU Group Programming
[0] [PLU] （PLU barcode）[Sub total][TOTAL]/[check]
There are total 10 groups and each group can include max. 50 PLUs.
Using group you
can
manage all PLUs and can take each group report to run your business.
When you first preset the group, the display format is as follow:
0 1 0 0 0 0
The PLU barcode*
The Group No. (1-10)
* It indicates the current group is blank. (The default value is none PLUs for each group)
The following are about the group operations:
1.
Displaying the next PLU barcode of the current group, when up to the last one, will skip
to next group.
-----[subttl]
2. Deleting the current PLU of the current group -----[VOID]
3. Deleting the designated PLU
-----（PLU barcode）[VOID]
If the PLU does not exist, it will have no error tip.
4. Adding designated PLU for the current group.
-----（PLU barcode）[subttl]
If the PLU has already existed, it will be designated
and display it.
5. Printing the current group -----[check]
6. Switch to other group
-----（group NO.）[PLU]
After preset the PLU parameter of current group you can press [check]Key for printing
them.If PLU amount is large, you can press [C]key to terminate the printing.
7.4 System Option Preset
This operation is provided for your selections of the register’s basic functions according to
the market and your requirements.
（A）[qty/time]（FLAG SET）[SUBTLL] [TOTAL]/[check]
Next Option Flag
Repeat if needed