Web-based Configuration Guide FAQs
26
8 FAQs
Q1: I failed to log into the web management system. What can I do?
(1) Verify that the Ethernet cable is properly connected to the LAN port of the device and the LED indicator blinks
or is steady on.
(2) Before accessing the web management system, you are advised to configure the PC with a static IP address
in the same network segment as the device IP address (default device IP address: 10.44.77.200 and subnet
mask: 255.255.255.0). For example, set the IP address of the PC to 10.44.77.100 and the subnet mask to
255.255.255.0.
(3) Run the ping command to test the connectivity between the PC and the device.
(4) If the login failure persists, restore the device to factory settings.
Q2: What can I do if I forget my username and password? How to restore the factory settings?
(1) Log in with the default username and password (default username/password: admin/admin).
(2) If you fail to log in with the default password, restore the factory settings. To restore the factory settings,
please power on the device, and press and hold the Reset button for 5s or more, and release the Reset
button after the system LED indicator blinks. The device automatically restores the factory settings and
restarts. After device restart, you can log into the web management system by accessing the default
management IP address (10.44.77.200).
To Previous Page
Loading...
Need help?
General