RWD MP-500 - Safety Function

6
 To prevent the risk of fire or electric shock, do not expose this device to rain or any type of
moisture;
 Do not expose this device to direct sunlight;
 Do not place heavy objects on the device;
 Microelectrodes pulled by this device have sharp tips.
Please do not touch the tips with
your hands
;
 Microelectrodes pulled should be placed in the attached electrode storage box to prevent
the tip of the microelectrode from collision and damage or to prevent dust particles from
entering the microelectrode and blocking the tips;
 The microelectrode should be placed in sharp container and sealing for safety after use.
 Do not disassemble this device. Only after-sales maintenance personnel designated by RWD
can disassemble the device or repair accessories.
2.3-Safety Function
 The device is equipped with a low light transmittance cover covering the entire pulley
assembly, which can isolate the hazardous factors that may occur during the pulling
process, including the heat of the filament, dazzling light, and the rapid movement of the
clamping arm.
 If the heating function is abnormal, the device will automatically turn off the power.