22
Click on the [Main Interface] as shown in Figure 4-2 to enter the [Setting]
interface.
Figure 4-17
Preheat jaws to 70°C.
Turn on the “Preheat jaws to 70°C” function,
referring to 4.10 Preheat jaws.
Select the language as Chinese or English.
Set system date and time.
System diagnosis
Diagnostic system, including pressure, heat, pull,
and velocity diagnosis.
Help
Including about this puller, track leakage, install
filament, install glass, and preheat jaws.
System maintenance
For adjusting screen brightness and for system
maintenance by after-sales personnel.
To Next Page
Loading...
