RWD MP-500 - 2 Important Information and Security; Labels; Safety Cautions; General Safety

5
2-Important information and security
2.1 Labels
High temperature warning
Caution! High temperature!
Do not touch the heating filament and jaw with your hands. After pulling, wait for
the air pump to finish spraying and then gently pinch the end of the microelectrode
to remove it. Take care to avoid the tip of the microelectrode.
2.2 Safety Cautions
2.2.1 General safety
 Please follow the instructions of all safety warnings and instruction labels on the device and
in the manual;
 The device should be operated by trained professionals;
 The device is only allowed to operate within its applicable scope, and only accessories
suitable for this device are allowed to be used. RWD shall not be responsible for any device
damage caused by any non-conforming operation, including the damage to a third party.
2.2.2 Safety Instructions
 Radio interference For Class A equipment that emits radio interference specified in the EN
61326-1/EN 55011 Standard, this device is designed and tested in accordance with Group 1
Class A in CISPR11.
Warning!
Class A equipment is used in an industrial environment. Due to the conduction
disturbance and radiation disturbance of the equipment during use, it may be difficult to
ensure electromagnetic compatibility in other environments.
 The device should be installed in a well-ventilated location, and the distance between the
device and the wall is at least 20 cm to ensure that the ventilation is not blocked;
 The device should be kept away from the flammable and explosive locations;
 To prevent the risk of electric shock, the power wire of this device can only be connected to
a grounded three-hole socket;
 Do not put anything into the device from the gap, otherwise it may cause a fire or electric
shock. Do not spill any liquid on the device;