3
The mechanical structure specially designed for the capillary glass makes the installation
and removal of the glass more convenient and safer.
The safe heat mode can avoid the damage of the filament from high temperature.
The preheating and constant temperature function can reduce the influence of the
accumulation of jaw heat on the consistency of the pulling results during continuous
pulling.
Two microelectrodes with symmetrical tips are stably produced every time. The diameter of
the tip can be less than 0.1 micron, the taper length 3-15 mm, and the impedance range
from 1 to above 100 megohm with high repeatability.
The system diagnostic function can be used to automatically check whether all components
of the puller are in normal working condition.
The copy-and-paste function makes it easier to copy existing programs.
The device can store up to 99 pulling programs.
7-inch capacitive color touch screen
530×355×278 mm(length×width×height)
Time mode (1-255), Delay mode (1-255)
To Next Page
Loading...
