RWD MP-500 - 1 Introduction; Overview; Safety; Product Introduction

1
1-Introduction
1.1 Overview
First of all, thank you for choosing MP-500 Micropipette Puller made by RWD!
Please be sure to carefully read all the information attached before installing and using this
product for the first time, which will help you use the product better.
RWD Life Science Co., Ltd. is committed to continuously improving product functions and
service quality, and reserves the right to make changes to any product described in this manual
and the content of this manual without prior notice.
For the latest product information, please contact us by telephone or mail, or visit our website
(www.rwdstco.com
). Please contact RWD if you find any inconsistency between the actual
product and the information contained herein during the use of the device, or when you have
any questions or suggestions.
 Model: MP-500 Micropipette Puller
1.2 Safety
When operating the device, users should read the section
2-Important information and
security
to avoid injury to the operator and damage to the device during use.
If you have any questions or suggestions on safety, please contact us for after-sales service
support.
The device should be operated and managed by trained professionals!
This device is not intended for medical use. Microelectrodes pulled by
this device should be used only for animal experiments in a laboratory
environment, but not be applied on human bodies in any form.
1.3 Product introduction
The Micropipette Puller consists of a heating assembly, a pulley assembly and an air cooling
system. It can make a single capillary glass softened by high temperature heating and then
pulled into two glass microelectrodes with symmetrical tips. It is mainly used by experimental
operators for patch clamp experiments and microinjection operations in the laboratory
environment in universities, research institutions, hospitals and assisted reproductive