16
Click to create a new program, and enter the [Main Interface] to open a new program;
Click to copy the selected program parameters and enter the [Main Interface] to
open a new program;
Click to rename the selected program;
There are 6 factory setting programs in [Default program]. Click the selected program to open it
in the [Main Interface].
4.8 Remove microelectrode
After pulling, hold the end of the microelectrode with one hand, loosen the knob with the other
hand, and take out the microelectrode on both sides from the top of the V-groove.
The temperature of the newly pulled microelectrode is very high. Please do not
approach the heating chamber!
When removing the microelectrode, do not slide along the groove, otherwise the tip of
the microelectrode may be hit and damaged.
In order to avoid excessive microelectrode impedance caused by continuous
pulling and cool down the jaw temperature to a suitable range, wait for 1 minute
to start pulling again after the microelectrode is pulled!
4.9 Pull results
Click on the [Main Interface] to view each pull result of the microelectrode.
Figure 4-13
To Next Page
Loading...
