9
Softening point
The range of current value causing the filament generating enough heat
that can soften the glass is 1-999
The range of air pressure to cool glass and the heating filament is 1-999
Puff(s)
The reasonable range of duration of the humidity control chamber
being filled with dry gas at the beginning and the end of the pulling is
Safe heat
In order to avoid unstable pulling or burning the heating filament, the
heat cannot be lower or higher than 10% of the softening point
Time
The range of duration of puffing to cool the glass and the heating
filament during the pulling of the microelectrode is 1-255
The range of delay time of heating stop and pulling start is 1-255
Display the current temperature of the jaw
Cycles
The number of heating cycles. The number of cycles per line ranges
from 1 to 10
The heat range of the heating filament is 1-999
The pulling force applied to both ends of the glass ranges from 0 to 255
The velocity of pulling apart the glass ranges from 1 to 255
To Next Page
Loading...
