EasyManua.ls Logo

Ryobi RM480e - Safety Interlock System Operation

Ryobi RM480e
46 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
WARNING
Firmly hold the deck height adjustment lever
fwhen setting the deck height and release
only when it is secure in the preferred slot.
Quickly letting go of the lever may create a
pinching or pulling hazard to the operator’s
hand.
DECK HEIGHT
ADJUSTMENT
LEVER
Fig 12
SETTING THE CRUISE CONTROL
See fig. 13
Cruise control allows the product to remain at
a constant speed without the operator having
to maintain pressure on the accelerator pedal.
It should only be used in the forward position
on relatively smooth, straight surfaces, and
should never be used on slopes or rough
terrain.
To set the cruise control:
While driving the product forward, press the
accelerator pedal until the preferred speed is
achieved.
1. Press the cruise control button. The light
around the button illuminates to show that
cruise control is active.
2. Release pressure on the accelerator
pedal. The mower speed should remain
constant.
To release the cruise control:
1. Step on the accelerator pedal.
2. Release the brake pedal, or press the
cruise control button again. The light
around the cruise control button will go
out to indicate that cruise control is no
longer active.
CRUISE CONTROL
BUTTON
Fig 13
CHARGING THE PRODUCT
See fig. 14 - 15
Mower batteries must be charged for 24 h
before rst use. To verify that the mower
batteries are fully charged, check the battery
level indicator.
For best results:
Do not charge the product in an area of
extreme heat or cold.
Never charge a frozen battery.
Mount or place the charger in an area with
adequate ventilation, without covering the
cooling fins.
Make sure both the charger and mower
connections are clean and free of dirt or
debris.
To charge:
1. Connect the charger plug into the
charging port on the mower, making sure
that it is properly connected.
2. Connect the charger to a power supply
that uses normal household current of
100-240 VAC, 50/60 Hz. The batteries
should automatically begin to charge.
3. When you are ready to mow, disconnect
the charger from the power supply, then
disconnect the charger from the mower.
23

Other manuals for Ryobi RM480e

Related product manuals