1. Park the product on a level surface.
2. Raise the cutting deck to the highest
position.
■ Position and secure a ramp to the trailer
according to manufacturer’s instructions.
NOTE: Use one full width loading ramp that
is at least 30.5 cm wider than the mower to
minimize the risk of the mower’s wheels going
o the side of the ramp.
3. Slowly drive the product onto the ramp
and into the trailer.
4. Set the cutting deck to the lowest height.
5. Engage the parking brake.
6. Turn off the product, engage the parking
brake, and remove the start key.
7. Secure the product as needed using
straps or cables to prevent movement
during transport.
WARNING
To avoid accidental starting or movement
of the product that could result in serious
personal injury, always remove the start
key and engage the parking brake when
transporting the product.
Fig 21
MAINTAINING THE PRODUCT
WARNING
Turn o the product, engage the parking
brake, and remove the start key. Make
sure that all moving parts have come to
a complete stop before performing any
maintenance tasks to avoid accidental
starting and possible serious personal
injury.
WARNING
Always wear eye protection with side shields.
Failure to do so could result in objects being
thrown into your eyes resulting in possible
serious injury.
WARNING
When servicing, use only original
replacement parts. Use of any other parts
can create a hazard or cause product
damage.
WARNING
Strictly adhere to all torque wrench
tightening specications. Failure to do so
could cause serious personal injury.
WARNING
Before each use, inspect the entire product
for damaged, missing, or loose parts, such
as screws, nuts, bolts, and caps. Securely
tighten all fasteners and caps, and do not
operate the product until all missing or
damaged parts are replaced. Contact an
authorised service centre.
General maintenance
Avoid using solvents when cleaning plastic
parts. Most plastics are susceptible to damage
from various types of commercial solvents
and may be damaged by their use. Use clean
cloths to remove dirt, dust, oil, and grease.
29
To Next Page
Loading...
