EasyManua.ls Logo

Ryobi RM480e - Ride-on Mower Safety Warnings

Ryobi RM480e
46 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
or at temperatures outside the specified
range may damage the battery and
increase the risk of fire.
SERVICE
Have your power tool serviced by a
qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool is
maintained.
Never service damaged battery packs.
Service of the battery packs should only
be performed by the manufacturer or
authorised service providers.
RIDE-ON MOWER SAFETY WARNINGS
Before use, always visually inspect to
ensure that blades, blade bolts, and cutter
assembly are not worn or damaged.
Replace worn or damaged blades and
bolts in sets to preserve balance.
The blade on the product is sharp. Use
extreme caution and wear heavy-duty
gloves when fitting, replacing, cleaning, or
checking bolt security.
Bring the product to an authorised service
centre to replace damaged or unreadable
labels.
Check all nuts, bolts, and screws at
frequent intervals for proper tightness to
be sure that the product is in safe working
condition.
Frequently check the bagger kit for wear,
holes, or deterioration.
Replace worn or damaged parts before
operating the product.
The product must be started with the user
properly seated and behind the steering
wheel. Never start the product if:
Not all four wheels are on the ground.
The side discharge chute is exposed
and is not protected by the bagging kit
or the mulch cover.
Hands and feet of all persons are not
clear of the cutting enclosure.
Do not force the product. It will do the job
better and safer at the speed for which it
was designed.
Stop the blade when crossing gravelly
surfaces to avoid discharging gravel
and rocks. Drive the product slowly and
carefully to avoid loss of control.
Turn on the motor carefully according to
instructions, and keep hands and feet
away from blades. Do not put hands or feet
near or under rotating parts.
Before and while reversing, look behind
and down for small children, bystanders,
and pets.
Be especially careful before and when
backing with the bagging kit installed, as
it may limit visibility. Always look closely
behind and down for small children,
bystanders, and pets, and move the mower
slowly.
Never carry children, even when the
blades has stopped. They may fall off and
be seriously injured or interfere with the
safe operation of the product. Children
who have been given rides in the past
may suddenly appear in the mowing area
for another ride and be run over or backed
over by the product.
Never leave a running product unattended.
Always engage the parking brake, stop the
blades, turn off the product, and remove
the start key before dismounting.
Check the brakes before each use and
frequently during use. Adjust and service
as required.
Keep hands and feet away from the cutting
area, which is located under the mower
deck and inside the side discharge chute.
Keep clear of the side discharge chute
opening at all times. Do not reach under
the mower deck.
Maintain the product with care. Keep
the product in good working condition.
Keep blades sharp and guards in place
and in working order. To prevent serious
personal injury, damage to the product,
and to maintain best performance, replace
damaged or unevenly worn out blades.
Turn off the product, engage the parking
brake, and remove the start key. Make
sure that all moving parts have come to a
complete stop before cleaning the product,
removing the bagging kit, or removing the
mulch cover.
Turn off the product, engage the parking
brake, and remove the start key. Make
sure that all moving parts have come to a
complete stop:
before leaving the product unattended
(including disposal of grass clippings)
3

Other manuals for Ryobi RM480e

Related product manuals