Saab TankRadar
®
Pro Pro Display Panel
5-19
Edition 2. Ref. No: 306010E
Note! See chapter Tank Distances for further information on how to set
the tank geometry parameters.
The following steps are only applicable when a non-standard
antenna is used.
5 Set the Holdoff Distance (H). The Hold Off distance defines how
close to the RTG reference point a level value is accepted. Normally
the Hold Off distance does not need to be changed. However, if
there are disturbing echoes in the upper part of the tank, for ex-
ample from the tank nozzle, you can increase the Hold Off distance
in order to avoid measurements in the region close to the antenna.
6 Set the Tank Connection Length TCL. This value is set automati-
cally when you use one of the standard antennas.
To Next Page
Loading...
