INDEX
Firmware – S2011 and S3012
Revision: 1 (9/98) 96 © Saftronics, Inc.
frequency reference setting method from digital operator, 84
frequency reference upper limit, 41, 85
frequency resolution, 70
frequency setting power supply, 10
frequency setting signal, 70
function selection at LOCAL/REMOTE switching, 92
FWD/REV run command, 92
G
ground fault, 70
ground fault interrupter, 11
ground terminal, ii, 11
grounding, 12, 66
H
heatsink overheat, 66, 70
heatsink overheating, 68
humidity, 70
I
input phase loss detection delay time, 87
input phase loss detection level, 87
input voltage, 84
instantaneous overcurrent, 70
intake air temperature, 8
integral time, 88
Inverter capacity, 70
Inverter kVA setting fault, 68
Inverter motor, 57
Inverter overheat pre-alarm, 68
Inverter overload, 66
Iron loss, 87
J
jog frequency, 85
jump frequency, 44, 87
jump frequency range, 87
K
kVA selection, 89
L
limit of integral value, 88
line voltage, 26
load short-circuit, 66
LOCAL, 25
LOCAL/REMOTE key function, 84
LOCAL/REMOTE selection, 51
location, 70
loop test, 53
M
Magnetic Contactor, 11, 12
magnetic starter, 12
main circuit, 11
main circuit configuration, 15
main circuit fault, 66
main circuit power supply, iii, iv
main circuit terminal, 13, 14
main circuit undervoltage, 66
master analog input selection, 53, 86
master frequency reference, 10
maximum applicable motor output, 3, 70
maximum output frequency, 84
maximum output voltage, 70
maximum voltage, 84
maximum voltage output frequency, 84
MC fault, 66
middle frequency voltage, 84
middle output frequency, 84
minimum baseblock time, 86
minimum output frequency, 84
minimum output frequency voltage, 84
MEMOBUS BPS selection, 88
MEMOBUS frequency reference unit, 61, 88
MEMOBUS parity selection, 88
MEMOBUS slave address, 61, 88
MEMOBUS, stop method at communication error, 88
MEMOBUS time over detection, 88
MEMOBUS transmission error, 68
MEMOBUS transmission fault, 67
MEMOBUS transmission waiting, 68
molded-case circuit breaker, iv, 11, 64
momentary power loss, 70
momentary power loss ridethrough method, 86
monitor, 92
monitor display, 92
motor line to line resistance, 87
motor no-load current, 89
motor overload, 66
motor overload detection, 57
motor overload protection, 70
motor overload protection selection, 57, 85
motor rated current, 57, 85, 93
motor rated voltage, 84, 93
multi-function analog output, 10, 86
multi-function contact input, 10
multi-function contact input selection, 85, 86
multi-function contact input setting error, 68
multi-function contact output, 10
multi-function contact output selection, 86
multi-step speed reference, 21
multi-step speed selection, 39
multi-step speed setting, 10
N
nameplate, 2
No. of V/f patterns, 70
O
OFF-delay timer, 87
offset, 88
efesotomasyon.com - Control Techniques,emerson,saftronics -ac drive-servo motor
To Next Page
Loading...
Need help?
General
