6-
dvanced parameters
F@ST 2704R Reference Manual - 253526032-A
Sagemcom Broadband SAS document. Reproduction and disclosure prohibited
Page 6-121
6.7 Diagnostics
Object: This menu is used to display all the tests performed on the connections made from your router to
your Internet Service Provider (ISP). These tests concern:
• connection to your local network (LAN),
• connection to your "DSL Service Provider",
• connection to your "Internet Service Provider".
Note
A hypertext link (help) enables the user to access context-related help. This help
gives an explanation concerning the state of the connection (PASS in green,
DOWN in orange and FAIL in red) and supplies the appropriate troubleshooting
procedures.
The ADSL line translates the three statuses detailed in the table below.
State
Meaning
PASS
Indicates that the test was completed successfully.
DOWN Indicates that an interface (ETH, Wi-Fi) has not been detected.
FAIL
Indicates that the test has failed, or that it is impossible to start a command.
If a test fails, proceed as follows:
1. Click on the corresponding Help link to access detailed information and problem-solving procedures.
2. Click on Test to check the problem is solved and resume the connection tests.
To access the Diagnostic tool:
• Select the Diagnostics menu.
To Next Page
Loading...
Need help?
General
