Page
-2 F@ST 2704R Reference Manual - 253526032-A
Sagemcom Broadband SAS document. Reproduction and disclosure prohibited
-
nnex
- Troubleshootin
A.1
Checking
the
assignment
of
an
IP address
In Windows Vista, XP, 2000 and ME
1. Click on Start > Run, enter cmd and then click OK.
The command prompt screen appears.
2. Enter ipconfig then press Enter.
3. Check that the entry IP Address contains a value other than 0.0.0.0 (for example 192.168.1.10).
Note
Note
If no IP address is displayed, enter ipconfig /release then enter ipconfig /renew.
All the troubleshooting procedures described below are undertaken in
Windows® XP. These procedures in other Windows operating systems® (98, ME
and 2000) can be slightly different.
Many sources of information are available to help you identify and resolve issues you may experience:
• the LEDs on the front panel of the router.
• the HTTP configuration tool.
For step-by-step and advanced problem-solving procedures, use the Diagnostic tool available in the HTTP
configuration tool.
To Next Page
Loading...
Need help?
General
