Page 13-2 F@ST 2704R Reference Manual - 253526032-A
Sagemcom Broadband SAS document. Reproduction and disclosure prohibited
13-
nnex
13 - Default configuration
This section details the values of the default parameters of your F@ST 2704R when it leaves the factory.
These default parameters can be modified by a particular preconfiguration of your F@ST 2704R.
13.1
Default
username and
password
Username: admin
Password: etdm (*)
(*) see information given on the router sticker
Note
The Username and Password can be different according to the ISP (Internet
Service Provider).
13.2
Default configuration for the local network(LAN)
The following table details the values of the principal LAN parameters of your router (LAN1 to LAN4):
LAN characteristics
Value
State
LAN1 IP address Internet and HTTP configuration tool access
(bridged)
LAN2 IP address
LAN3 IP address
LAN4 IP address
192.168.1.1/24
BROADCAST, ARP, MULTICAST
_
Activated
Router
_
The LAN traffic is routed to your ISP
NAT/PAT
_
Activated
13.3
Default configuration for the local
wireless
network (WLAN)
The following table supplies the principal default WLAN parameters of your router.
Characteristics (Wi-Fi)
Value
IP address
192.168.1.1/24
Enable Wireless Box
checked
SSID SAGEM_3325
(*)
(*) see information given on the router
sticker
Channel
Auto
Network Authentication
No
To Next Page
Loading...
Need help?
General
