Sam4s ER-260EJ/256EJ OP Manual v1.20 Program Mode Programming • 145
Option Entry Description
38 CHECK CHANGE LIMIT 8 DIGIT
Use this program to set the maximum amount of cash that
can be returned when a check is tendered for an amount
greater than the amount of the sale. For example: if the
check change limit is $10.00 the maximum amount that
can be tendered into the check key on a $5.00 sale is
$15.00.
39 TARE WEIGHT
TARE1
TARE2
TARE3
TARE4
TARE5
4 DIGIT
A tare is the amount of weight representing the container,
or package when items are sold by weight. You can pre-
program five tare weights, representing the weight of
different containers. When you place an item and a
container on an optional scale, you can enter the tare
number to automatically subtract the pre-programmed tare
weight. If you choose to use tare #5 for manual tare
weight entry, do not enter a weight for tare #5.
40 MACHINE NO. 5 DIGIT
The machine number is printed on the register receipt.
Program a machine number so that any receipt can be
identified with the store or register where the transaction
took place.
41 MODE P/W 6 DIGIT
If you wish to use mode password, you must program a
password that you will use to enter X mode, Z mode,
PROGRAM (P) mode and SERVICE (S) mode. The
password may be up to 6 digits. (Used with option 33)
42 LANGUAGE SELECT ENGLISH
SPANISH
FRENCH
Descriptors for menus, system and options can be
converted to the selected language automatically.
Descriptors for Reports, PLU’s, Groups, etc. are not
converted. Those descriptors can be changed only by user
programming.
43
USE RECEIPT AS
DETAIL
Y or N
Select Y if you wish to print sale receipt as detail printer
format (journal printer). If Y you can program some
options of DETAIL PRINT option.
44
NOT INCREASE RCPT#
AT CLK IN/OUT
Y or N
Select Y if you do not wish to increase the receipt number
(counter) when signing on or off a clerk.
45 EFT DRAFT DATATRAN
FINE DINING
Select if the EFT draft is fine dining. Fine dining draft will
print a tip line. Select Datatran to not print tip line.
46 MSR CONNECT DATATRAN
PDC
Select if the card reader is connected to the Datatran
device or the PDC
47 PIN PAD TYPE DUKPT
ROTAT
Always choose pin pad type as DUKPT.
48 PIN PAD PORT 0-3 Select the port# where Pin-Pad is connected
49
COPY OF DATATRAN
RECEIPT
0-99 Set desired number of EFT receipts to print (0-99)
(default = 1)
50
MARK CARD No ON ALL
EFT DRAFTS
Y or N Set to N to NOT print card number on EFT receipts.
To Next Page
Loading...
