Sam4s ER-420F - Installation Procedures

3 Installation and Operation
3-2 SAM4S ER-420M/F SERIES
3-2 Installation
3-2 A. Paper Roll Installation
1. Open the PRINTER COVER.
2. Place a paper roll onto the concave bottom of the paper supply after the leading edge of the paper
is being fed from the bottom of the roll.(Figure 3-2-1)
3. Using the Paper Auto-feed-Insert the leading edge of the paper into the slot between the Platen Roller
and the Cover Guide until the paper is fed automatically by sensor.(Figure 3-2-2)
4. Using the Paper Manual-feed -Pull up the LEVER LOCK and the leading edge of the paper into the slot
between the Platen Roller and the Cover Guide until the paper is fed to the Paper-Exit, between the
TPH and Platen Roller. Return the LEVER LOCK.(Figure 3-2-3)
5. Tear the end of the paper on the left at the receipt printer like the shown figure.(Figure 3-2-4)
6. Push the button for paper feed on the keyboard to take up the leading edge of the paper to the Spool
Winding on the journal printer on the right.(Figure 3-2-4)
7. Feed the leading edge of the paper in about 150mm and fold the tip in 20mm. Insert the leading edge of
the paper into the slot on the Spool Winding.(Figure 3-2-5)
8. Insert the Spool Winding into the hole of Guide Winding like figure.(Figure 3-2-6)
9. Turn the Spool Winding in 2~3 turns.(Figure 3-2-7)
10. Place the Spool Winding on the Paper Supply. If it loosen, turn to tighten it.(Figure 3-2-8)
11. Close the PRINTER COVER.
YES
NO
(Figure 3-2-1) (Figure3-2-2) (Figure3-2-3) (Figure3-2-4)
(Figure 3-2-5) (Figure3-2-6) (Figure3-2-7) (Figure3-2-8)
Figure 3-2 Paper & Spool Installation