Sam4s ER-420F - Product Specifications; General Specification

SAM4S ER-420M/F SERIES 2-1
2 Product Specifications
Specifications are correct at the time of printing. Product specifications are subject to change without notice.
See below for product specifications.
2-1 General Specification
Item Description Remark
Processor
• MITSUBISHI M16C/80 Group M30800SFP (16 Bit)
External ROM Version
Memory
• RAM
SRAM (K6T1008C2E) : 1MBITs or 2MBITs
SRAM (K6T4008C2E) : 4MBITs × 1EA(Option)
• ROM
EPROM : 4MBITs (M27C4001)
FLASH ROM : 8MBITs (AM29F800BB)
Battery
• Type : Ni-MH, 3.6V 70mAh
• Charging Time : 24 Hours
• Life : 2 Years
Data Storage
• 60 Days
When battery is Full
charged
Interface Serial
(RS-232C)
• Flow Control :
① DTR / DSR : H/W Flow Control
② XON / XOFF : S/W Flow Control
• Baud Rate : 1200 / 2400 / 4800 / 9600 / 19200 Bps
• Connector : DB9P Female (I/F PBA)
• Voltage Supply : VCC(+5V/200mA) supplies at 9Pin of Connector.
RS-232C #1
RS-232C #2
Printer
• Model : Shin-Heung STM-320
• Print Speed : 75 mm/Sec ( 20 Line/sec)
Detail Spec refer to Next
Page
Display
• Operator Display : 16*2 Character LCD or 10 Digits VFD
• Customer Display : 10 Digits VFD
Key Board
• Raised Key : 48 key
Power Consumption
• Approx. 25W (Regularity)
Power Requirement
• AC 120V 60Hz, 230V 50Hz
Environment
Condition
• Temperature : 0℃ ~ 45℃
• humidity : 30% ~ 80% RH
Dimensions(mm)
400(W) x 450(D) x 266(H) ; with Drawer
Set
Table2-1 General Specification