3 Installation and Operation
3-6 SAM4S ER-420M/F SERIES
3-3 D. All Clear
This step insures that the cash register is cleared of any totals or programming. After this procedure, the cash
register is ready for programming and operation.
WARNING: This is a one time procedure. Do not repeat this procedure after the cash register is
programmed, it causes all programs and totals to be erased and to be default.
Note : Service Mode is not marked in a mode painting part.
Service Mode spins the Mode Key once just in a Program Mode to the right direction.
And need “ C Key ” to execute a Service Mode.
1. Turn off the power switch.
2. Turn the Mode switch to Service Mode position.
3. Press and hold the CHECK key on key board and turn on the power switch at the same time.
4. When the buzzer beeps, press ‘FEED’, ‘PLU’, ‘RECD ACCT’, and ‘CASH/TEND’ in sequence.
5. When memory is cleared, the register prints a message “RAM ALL CLEAR OK!
”
Figure3-7 All Clear Key Sequence & Print Sheet
DATE 01/31/2004 FRI TIME 16:01
= = = = = = = = = = = = = = = = = = = = = = =
RAM ALL CLEAR OK !
ER-420M EPROM INFO.
VERSION : STD 1.0
CHECKSUM : 887C
JANUARY 31 2004
= = = = = = = = = = = = = = = = = = = = = = =
CLERK 00 No.000001 00000
To Next Page
Loading...
