SECTION III USE
Creeper range selector lever
A - ENGAGED
B - DISENGAGED
WARNING: The forward-reversing gear unit control lever should only be
used when the tractor is fully stationary
Front and rear differential lock
The differential lock should ONLY be used when on a straight path and
before excessive wheel spin occurs.
The tractor is equipped with electro-hydraulic control: to engage the
differential lock, push control butto which remains in position and will light
up due to built-in pilot lamp.
Press button again to disengage the differential lock.
A special pilot lamp on the dashboard indicates the
locking of the differentials.
N.B. - Absolutely do not engage the differential lock while a wheel is
spinning excessively. In this case, depress clutch pedal before locking the
differentials.
37
WARNING: DO NOT ENGAGE THE DIFFERENTIAL LOCK IN THE
FOLLOWING SITUATIONS: ON TRAVELLING AT SPEED ABOVE 15
KM/H, ON STEERING, WHEN THE TWO BRAKE PEDALS ARE NOT
LOCKED TOGETHER.
To Next Page
Loading...