SECTION V MAINTENANCE
Checking the transmission oil level
•
The tractor must be parked on a flat, horizontal surface.
•
The engine must have been switched off for at least 5 minutes and
the handbrake must be on.
•
The rear power lift must be lowered and the arms of the front
power lift (if present) in the raised position.
•
The control levers of the remote service control valves must be in
neutral position.
•
Check the oil level through the clear round inspection window 1
(see figure below).
•
If necessary add oil of the specified type until the level reaches the
bottom of the oil filler hole.Re-start and run the engine for a few
minutes, then check the oil level again.
•
Once you have finished adding oil, replace the clear plug in the oil
filler hole.
Rear view of tractor
1 - Gearbox oil level plug (rear part)
2 - P.T.O. shaft protective case
3 - Gearbox oil drain plug
140
WARNING: FOR THE WHEELS REPLACEMENT AND FOR SOME
MAINTAINING OR REPAIRING OPERATIONS, THE TRACTOR MUST
LIFTED, USING SPECIFIC SAFETY SUPPORTS. NEVER USE AS SUP
-
PORT THE IMPLEMENTS ATTACHED TO THE TRACTOR. DO NOT
ALLOW ANYONE TO GET ON THE TRACTOR, WHEN LIFTED FROM
THE GROUND FOR MAINTENANCE OR REPAIR OPERATIONS.
To Next Page
Loading...
Need help?
General
