SECTION V MAINTENANCE
Maintenance of the heating system
The heating system utilises heat from the engine cooling system.
Every 1200 hours (or every 2 years): flush out the heating system along
with the engine cooling system when the AKROS FREEZE coolant is
changed.
During this operation the tap located on the right of the dashboard must be
open, i.e. control knob turned fully clockwise.
Each season, check the supply and return lines for leaks.
Check belt tension: when firm thumb pressure is applied in the mid point
between the two pulleys, the belt should deflect 5 to 8 mm (0,20 to 0,32 in)
at most.
In case of system operation failure or interruption, check the system fuse.
If the air does not start coming out of the outles right away as soon as the
system is set at work, immediately switch it off and identify the fault.
When switching on the system, always make sure the air intake ducts and
the diffusers are not blocked.
Never turn on the heating system in dusty environments when the doors
are open.
IMPORTANT: Never attempt to carry out any work on the heating system
with running engine.
A - External air inlet grille
B - Air conditioning refrigerant cooling grille
152
To Next Page
Loading...
Need help?
General
