SECTION I SAFETY/DECALS/SYMBOL
XLIV
After Operation
When stopping at any time, bring the tractor to a complete halt, apply the
parking brake, disengage the P.T.O., place the lowest gear engaged,
lower the implement to the ground, stop the engine and remove the key
BEFORE leaving the seat.
Welding work on the tractor body
Before performing electrical welding work on the tractor body or on
attached implements, always disconnect the electrical wiring of the
generator, the battery and the electronic boxes.
Welding work on the cab posts is not permitted.
Watch out that plastic components, such as air compressor system or
hydraulic hoses, are not overheated.