SECTION V MAINTENANCE
WARNING: when the filter clogged warning light comes on, have
the oil filters changed immediately. Change the oil filter located on the
left-hand roll bar support
N.B. If warning light continues to stay on after changing filter(s),
contact a authorized service centre. It is normal for the light to stay on
for a few minutes immediately after starting the engine.
Procedure for changing the transmission oil filters
–
Position a suitable receptacle underneath the filter.
–
Unscrew the cartridge.
–
Oil the new cartridge using the same oil as that used in the transmis-
sion.
–
Screw on cartridge, tightening by hand only.
–
On starting the engine, check for leaks around the cartridge sealing
ring.
–
Check the transmission oil level.
Gearbox oil filter
139
NOTE: If noises occur in hydraulic pumps at operating temperature, a dirty
oil filter could be the cause. in this case change the oil filter for the operating
hydraulics immediately.
NOTE: Always park the tractor on a level surface when changing the oil or
checking the level.
To Next Page
Loading...