SECTION III USE
Working with surface and underground implements with
simultaneous draft and position control - Mix control
When working with soil of variable conditions, to prevent the implement
from sinking more than necessary in terrains of minor consistency, the
power-lift control levers should be positioned in such a way to obtain both
implement effort and position control.
For mixed control, start work and position the levers as described in "draft
control work", then move the yellow lever backwards along the sector
(yellow and green) until lifting commences; move the lever slightly forward
again (1-2 mm / 0.0394-0.0788 in) to immobilise the implement in position.
Working with float position
(e.g. sowing machine)
When the implement is to follow the ground contours, push the yellow
lever in the blue sector (FLOAT).
The green lever may be in any of the positions included between No. 6 and
No. 12 of its own sector.
At the beginning and end of each row act only on the yellow lever to raise
and lower the implement .
NOTE - The implements must always be lowered to the ground whenever
the tractor is not operating or when adjustment, maintenance or repair
operations are to be carried out.
49
To Next Page
Loading...
Need help?
General
