•
Operations prior to garaging the tractor for a long period .................179
•
Preparing the tractor for use after a long period of storage................180
•
SECTION8-Technical specifications................................181
•
Engine ........................................................181
•
Clutch ........................................................182
•
Power take-off ..................................................182
•
Gearbox ......................................................184
•
Gearbox ratios schematic .........................................185
•
Performance - Ground speed in km/h (mph) @ 3000 rpm ................186
•
Front driving axle................................................188
•
Hydrostatic steering system .......................................188
•
Front hydraulic lift ...............................................188
•
Hydraulic diagram of lift...........................................189
•
Hydrostatic steering system .......................................190
•
Cab..........................................................190
•
Dimensions and weights ..........................................191
•
Unladen weight of tractor (without ballast) ............................192
•
Unladen weight of tractor (with ballast) ...............................192
•
Maximum permissible loads .......................................193
•
Maximum trailerable loads ........................................193
•
Ballast weights .................................................193
•
Attachment of implements to the tractor ..............................194
•
Implement attachment points ......................................195
•
SECTION 9 - Fault diagnosis .......................................199
•
Engine ........................................................199
•
Gearbox ......................................................201
•
Rear power take-off..............................................202
•
Front driving axle................................................202
•
Brakes ........................................................202
•
Hydraulic lift....................................................202
•
Auxiliary hydraulic systems ........................................203
•
Appendix .........................................................A
•
Combination of tractor and mounted implement..........................B
•
Determination of the total weight, the axle loads, the tyre load carrying
capacity and the necessary minimum ballasting .......................B
•
Consideration of rear mounted implement and front/rear combinations......C
•
Front mounted implement.........................................C
•
Note .........................................................F
VIII
To Next Page
