Samson 3374-10 - 5 Mounting and Start-Up; Mounting the Actuator Onto the Valve; Mounting Position

EB 8331-4 EN 23
Mounting and start-up
5 Mounting and start-up
Risk of malfunction due to incorrectly performed start-up.
Perform start-up following the described sequence.
1. Mount the actuator onto the valve.
Î See section5.1.
2. Connect power supply.
Î See section5.2.
3. Initialize the actuator.
Î See section8.3.
5.1 Mounting the actuator onto the valve
5.1.1 Mounting position
The control valve can be installed in the pipeline in any desired position. However, a sus-
pended mounting position of the actuator is not permissible (see Fig.4).
 
!
Fig.4: Mounting position
NOTICE
!