Samson 3374-10 - Command Pen

EB 8331-4 EN 73
Memory pen
Table7: Memory pen dialog
Code Function Action Text
S02/
S03
Read data from memory pen/
Write data to memory pen
Reading memory pen/
Writing on memory pen
READ
WRIT
S10 Time-controlled data logging Data logging in progress TLOG
S11 Event-triggered data logging Data logging in progress ELOG
Table8: Memory pen error
Code Error Text
E51 Read error (memory pen) ERD
E52 Write error (memory pen) EWR
E53 Plausibility error EPLA
13.1 Command pen
The following executable commands can be written to the memory pen in TROVIS-VIEW:
− Retract actuator stem
− Extend the actuator stem
These commands turn a memory pen into a command pen. After inserting the command pen
into the actuator's interface, all functions running are ended and the command is executed
since the command pen has priority over all functions.
− A command pen remains active as long as it is inserted into the actuator's interface (even
after a reset).
− Only one command at a time can be written to the memory pen and executed.
Note