Samson 3374-10 - Page 74

74 EB 8331-4 EN
Memory pen
Using the command pen
1. Open the actuator cover.
2. Insert the command pen into the serial interface of the actuator.
Î The actuator automatically recognizes the command pen. The dialog for the command
pen is displayed. The function (command) selected in TROVIS-VIEW is represented by a
code on the display (see Table9).
3. Remove command pen after the command has been executed.
Î The command pen dialog ends. The start screen appears.
Close the actuator cover.
Table9: Command pen dialog
Code Command/function Text
S21 Retract actuator stem IN
S22 Extend the actuator stem OUT