104 EB 8389 EN
Leakage sensor
7.2.1 Resetting single status
messages
The short-term monitoring (diagnostic pa-
rameters, measured data and analysis) can
be reset by selecting and executing the com-
mand "Reset 'Short-term leakage sensor
monitoring'". The data in the Analysis of
measured data folder are reset as well.
Operation > Reset
− Reset 'leakage detection – short-term'
7.3 Long-term monitoring
To obtain a sound level trend over a long pe-
riod of time, the long-term monitoring con-
tains all the mean values saved in the short-
term monitoring since the last reset:
− 'Long-term average': The average sound
level calculated from 'Number of averag-
es'
− 'Number of averages'
Data are recorded in the background re-
gardless of the operating mode selected. Da-
ta logging does not need to be activated.
7.3.1 Resetting single status
messages
The measured data of the long-term monitor-
ing are reset by selecting and executing the
command "Reset 'Leakage detection - Long-
term monitoring'".
Operation > Reset
− Reset 'leakage detection – long-term'
To Next Page
Loading...
Need help?
General
