EB 8389 EN 47
Statistical information
4.5.2 Resetting single status
messages
The 'External leakage' message can be reset
by selecting and executing the command
"Reset 'Cycle counter histogram'".
By selecting and executing the "Reset 'Cycle
counter histogram'" command, all diagnostic
parameters and measured data of the histo-
gram and the short-term monitoring as well
as the 'Dynamic stress factor' are reset.
By selecting and executing the command
"Reset 'Cycle counter histogram - short-
term'", the measured data in the 'Short-term'
folder are reset.
Operation > Reset
− Reset 'Cycle counter histogram'
− Reset 'Cycle counter histogram – short-term'
To Next Page
Loading...
Need help?
General
