Samson 5824 Series - Operating Values; Service; Start-Up; Operating States

EB 5824-2 EN 45
Conguration
9.5 Operating values
The values in the Operating values folder cannot be changed.
In online mode, the current operating values are listed in the Operating values folder. De-
pending on the basic setting, operating values are plotted in a graph underneath.
9.6 Service
The Service folder is subdivided into the areas Start-up, Operating states, Functions, Status
messages and Statistics.
9.6.1 Start-up
InitializationcanbestartedintheService folder (Start-up).
9.6.2 Operating states
Error messages can be read in the Service folder (Operating states).
Operating states and errors are also indicated by the LEDs (see section8.1).
9.6.3 Functions/Service
ThefollowingfunctionscanbeperformedintheServicefolder(Functions):
Manual level
The actuator can be switched to the manual mode using the TROVIS-VIEW software if the
manual level is enabled in online mode. The actuator leaves the manual mode as soon as
youexitthemanuallevelortheonlinemodeinTROVIS-VIEW.
Thefollowingactionscanbeactivatedinthemanuallevel:
Note
Note