Samson 5824 Series - Command Mode

EB 5824-2 EN 53
Conguration
A change in the blinking pattern of the yellow LED indicates that data are being saved to
the memory pen.
2 4
6
8
10
On
Of
f
T
ime [s]
2. Data logging is completed when you remove the memory pen from the serial interface of
the actuator.
You can load a data logging le into the Trend-Viewer by selecting Load diagram ... from the
context-sensitive menu.
Transferring data onto a computer
1. Insert the memory pen together with modular adapter into the serial interface (COM
port)ofthecomputer(seeFig.17onpage54).
2. Select Read Logged Data from the Memory Pen menu.
3. Select the desired target directory. If the target directory is not changed, data will be
saved in the SAMSON folder > Type5824.
4. Enterthelename.
5. Click Save to start data transmission.
9.7.5 Command mode
In closed-loop operation, the actuator stem can be moved to the top or bottom end position
using the command pen regardless of the input signal.
Possiblesettings:
− No command
− Retract actuator stem
− Extendactuatorstem
Note