Samson 5824 Series - Copying Function; Data Logging

52 EB 5824-2 EN
Conguration
9.7.3 Copying function
ThememorypencanbeusedtocopysettingdatatootherTypes5824and5825Actuators
after the data from the actuator have been transferred to the memory pen.
“Automatically write to memory pen” is automatically reset to the read status after data are
transferred from the actuator for the rst time.
9.7.4 Data logging
Thememorypen-64allowsthefollowingdatatobesaved:
− Inputin%
− Actuatortravelin%
− Positionfeedbackin%
− Temperatureinsidedevicein°C
− Torqueswitch:Actuatorstemretracted
− Torqueswitch:Actuatorstemextended
− Position feedback is relative
− Error during operation
− Input signal failure
− Direction of action switch
− Functionswitchinitialization
The data are logged until the memory capacity of the memory pen is full.
DatainthememorypencanbesavedtoadataloggingleusingtheTROVIS-VIEWsoft-
ware.
Data logging
1. Plugthememorypenintotheserialinterfaceoftheactuator(Fig.16).
The yellow LED on the actuator indicates that the data logging is being prepared.
T
ime [s]
On
Of
f
2.8
5.6
8.4
1.4
4.2
7.0
Note