04 Connections
Connecting to a TV with an Audio/Video cables and RF cable
Connect the RF cable as shown.
Using video/audio cables, connect the VIDEO OUT (yellow) / AUDIO OUT (red and white)
terminals on the rear of the product to the VIDEO IN (yellow) / AUDIO IN (red and white) terminals
of your TV.
Plug in the product and TV.
Turn on the product and TV.
NOTE
The RF cable connection of this product sends only signals of TV. You must connect the Audio/Video cables to watch
output from your product.
Noise may be generated if the audio cable is placed too close to the power cable.
If you want to connect to an Amplifier, please refer to the Amplifier connection pages. (See pages 27~28)
The number and position of terminals may vary depending on your TV set. Please refer to the user manual of your TV.
If there is only one audio input terminal on the TV, connect it to the AUDIO OUT(right/white) terminal of the product.
1.
2.
3.
4.
✎
▪
▪
▪
▪
▪
Connections
To ANT IN
To TV
RF cable
To ANT INPUT
Audio/Video cable
WhiteRed Yellow
To Next Page
Loading...
