Samsung Jet Bot - Boundary Markers and Additional Functions

OPERATION
Additional functions
Additional functions Operation
Energy-Saving
Mode
• When charging is complete, the Jet Bot automatically enters the
Sleep Mode. While the Jet Bot is docked on the Clean Station,
press and hold the [
] for 7 seconds to set it to the Sleep Mode.
To cancel the Sleep Mode, start cleaning or press the [
] for
7seconds.
 When the Jet Bot is in the Energy-Saving Mode, the power is turned
off after charging is complete which means the Wi-Fi reception
waiting is not enabled, therefore the Jet Bot cannot be controlled
with the mobile app.
Downtime Mode
• You can set the Jet Bot not to clean within the Downtime at the
Settings.
 When Downtime comes, the Jet Bot returns to the Clean Station.
Scheduled Cleaning
• You can set the Jet Bot to clean at the Schedule.
 If the Jet Bot is detached from the Clean Station at the scheduled
time, the scheduled cleaning does not work.
Setting the No-go
Zones
• When the Jet Bot has saved a map, you can set the Jet Bot not to
enter a designated area.
 If the Jet Bot does not start cleaning from the Clean Station or the
installation place of the Clean Station has been changed, the Jet Bot
may clean the set No-go Zones.
 When setting the No-go Zones, you cannot include the Clean Station.
 You can set the Downtime mode, Scheduled Cleaning or No-go Zones at the SmartThings App.
NOTE
• When a Check Notice occurs or when you carry the Jet Bot to another place and start
cleaning, the Jet Bot spins left and right at a 30 degree angle to recognize its location before
it starts cleaning.
• If the Jet Bot cannot recognize its current location, it starts Auto Clean.
• The Jet Bot automatically performs a system check and restarts once a week.
English
20
1_VR8500_EN_00858C-02_SW.indd 20 2022-10-13 오후 6:06:13