Samsung Jet Bot - Cleaning and Maintenance

APPENDIX
Cleaning and maintenance
NOTE
• If you washed the Dustbin and lter with water
– Dustbin: Completely wipe out the water.
– Filter: Completely dry it in the shade before use.
• Do not use water to clean the Fine dust Filter, just shake it to clean.
• If suction power decreases continuously, or the Jet Bot overheats, clean
the Fine dust Filter.
CAUTION
• Watch your ngers when attaching or detaching the lter, since they may
get stuck in the Dustbin’s intake.
• To avoid blockages by foreign matter, do not let the Jet Bot vacuum up
toothpicks, cotton swabs, etc.
• If it is difcult to remove foreign matter from the brush, contact an
authorized SAMSUNG service center.
• Since the brush sweeps dirt up from the oor during cleaning, foreign
matter such as a thin and long thread, long hair, etc. may get caught in it.
For the best cleaning results, check and clean it regularly.
• Turn off the Jet Bot before cleaning or maintenance work.
• If a brush or a brush cover is not assembled correctly after the
maintenance work, scratches may occur on the oor, or product
malfunction may occur. Therefore, assemble them correctly by checking
the maintenance method.
English
36
1_VR8500_EN_00858C-02_SW.indd 36 2022-10-13 오후 6:06:29