Samsung P55 - Page 140

139
Q
In the following cases, the screen blinks or
displays noise for a short time (This only applies
to nVidia graphics card.): (Click the Graphics
Related tab, Change Resolution, Change Display
Device, Remove the AC Adapter, Restart the
System, Change PowerMizer level.)
A This may happen while the video driver is
examiningtheconnecteddevice.Whiledetecting,
anyconnecteddisplaydevicesmayblinkorsome
noise may occur.
Q
When I connect a projector, and change the
setting to display screen image on both the LCD
and the projector by pressing Fn + ( ) keys,
screen is not displayed properly.
A Press Fn + ( )keysonceagain.Ifthesameproblem
continues,itmeanstheprojectorcannotsupportthe
resolution.Lowertheresolutionto1024x768.
Q
The playback screen of a DVD title or an MPEG
le is only displayed on the LCD. (This only
applies to nVidia graphics card.)
A Video is displayed on a single display device
bydefault,whenLCDandCRTareselected
simultaneously.
 Right-clickovertheDesktop and select Properties
fromthepop-upmenu.
 In the Display Properties window, select Settings
tab
> Advanced > Ge-Force Go xxxxtab.
 Select the Full Screen Video menu > Full Screen
Video Control item, set the full screen device to
“AuxiliaryDisplay”andthenclickthe
Applybutton.
ThenyoucanviewvideoonboththeLCDandCRT
display devices.
Q
The Taskbar on the bottom of the screen does
not appear when a projector is used as the
display device.
A AThismayhappen,eventhoughSXGA+LCD
supportsthe1400x1050mode,theprojectordoes
not support that mode. In this case change the
resolutionto1024x768(recommended)onyour
computer.