17
The eight different remote control codes (Code 1–Code 8) are assigned to this projector. Switching the remote
control codes prevents interference from other remote controls when several projectors or video equipment
next to each other are operated at the same time. Change the remote control code for the projector first before
changing that for the remote control. See “Remote control” in the Setting Menu on page 53.
Press and hold the MENU and a number button (1–8)
for more than five seconds to switch between the
codes.
1
To initialize the remote control code, slide the RESET/
ON/ALL-OFF switch to “RESET,” and then to “ON.” The
initial code is set to Code 1.
2
Press and hold the MENU and a number button
(1–8) that corresponds to the remote control code
for more than five seconds to switch between
the codes.
MENU button
Remote Control Code
Number buttons
RESET/ON/ALL OFF
Switch
Part Names and Functions
Notes:
s7HENUSINGASAWIREDREMOTECONTROL
WHILETHESTANDBYMODEISSETTOh%COv
THESAMEREMOTECONTROLCODESHOULDBE
SETONBOTHTHEPROJECTORANDTHEREMOTE
CONTROLTOTURNONTHEPROJECTORP
Downloaded From projector-manual.com Sanyo Manuals
To Next Page
Loading...
Need help?
General
