63
Auto Lamp Selection System
This Projector is equipped with 2 Projection Lamps. The Lamp Management Function detects the status
of lamps and shows the status on screen or on the LAMP 1/2 REPLACE indicators. This function also
automatically controls the Lamp Mode when any of lamps reaches the recommended total hours of use or is
out for the end of life or malfunctions.
Projection Lamp lights normally.
Lamp 1/2Replace Indicators
The LAMP 1/2 REPLACE indicators light yellow when the total lighting time of a Projection Lamp reaches the
recommended total hours of use. Check the number of lamp on the Lamp Status Display or the LAMP 1/2
REPLACE indicators and replace the lamp.
Yellow Lamp
Dim Lamp
X Mark on Lamp
Red Lamp
LAMP 1/2 REPLACE
indicators
Projection Lamp is turned off.
The total lighting time of Projection Lamp reaches
the recommended total hours of use. (LAMP 1/2
REPLACE indicator lights yellow.)
(LAMP 1/2 REPLACE indicator flashes yellow.)
Projection lamp is defective or fails to be turned on.
Restart the projector on, and make sure lamp is on.
If this mark still appears, replace lamp corresponding
with number marked X.
LAMP STATUS
DISPLAY
Lamp Mode Changeover
The Lamp Management Function automatically changes the lighting lamp (Lamp Mode) by detecting the status of lamp.
When either of the 2 lamps is out, the projector operates with the other lamp. The Lamp Mode can be switched manually.
Refer to the SETTING section on page 52
.
LAMP 2 MODE
LAMP 1 MODE
When Lamp 2 is burnt out.
Lamp Status Display
The Lamp Status Display appears on screen when the projector is turned on or the input position (input 1, input
2, or Input 3) is switched. This shows the status of each lamp as; ON, OFF, NEAR END, or OUT. Refer to the
following for each status.
Lamp status
Maintenance and Care
When Lamp 1 is burnt out.
Lamp control
When the total lighting time of a lamp
reaches the recommended total hours
of use.
Red
Downloaded From projector-manual.com Sanyo Manuals
To Next Page
Loading...
Need help?
General
