Sanyo PLC-XTC50L User Manual

23
NOTE ON THE POWER CORD
AC power cord must meet the requirements of the country where you use the projector.
Confirm the AC plug type with the chart below and proper AC power cord must be used.
If the supplied AC power cord does not match your AC outlet, contact your sales dealer.
To power cord
connector on your
projector.
Projector side AC outlet side
Ground
To the AC outlet.
(120 V AC)
For Continental EuropeFor the U.S.A. and Canada
This projector uses nominal input voltages of 100–120 V or
200–240 V AC and it automatically selects the correct input
voltage. It is designed to work with single-phase power
systems having a grounded neutral conductor. To reduce the
risk of electrical shock, do not plug into any other type of
power system.
If you are not sure of the type of power being supplied,
consult your authorized dealer or service station.
Connect the projector with all peripheral equipment before
turning the projector on.
CAUTION
The AC outlet must be near this equipment and must be easily
accessible.
Connecting the AC Power Cord
Connect the AC power cord (supplied) to the
projector.
For the U.K.
To the AC outlet.
(200–240 V AC)
To the AC outlet.
(200–240 V AC)
Installation
Note:
s 5NPLUGTHE!#POWERCORDWHENTHEPROJECTORISNOT
INUSE7HENTHEPROJECTORISCONNECTEDTOANOUTLET
WITHTHE!#POWERCORDITISINSTANDBYMODEAND
CONSUMESALITTLEELECTRICPOWER
Downloaded From projector-manual.com Sanyo Manuals

Sanyo PLC-XTC50L Specifications

General

Brand	Sanyo
Model	PLC-XTC50L
Category	Projector
Language	English