61
Turn off the projector, press the Main On/Off Switch to
Off and unplug the AC power cord from the AC outlet.
First, clean up the dust on the projector and around the
air vents.
1
2
Slide and open the Filter cover. (See the right figure.)
3
Put the new one back into the position until it clicks and
close the filter cover. Make sure that the filter cartridge
is properly and fully inserted.
5
CAUTION
Make sure the filter cartridge is inserted in the
projector. If the filter cartridge is not inserted, the
projector cannot be turned on.
Make sure the filter cover is closed when using the
projector.
Do not put anything into the air vents. Doing so
may result in malfunction of the projector.
4
Reset the filter counter and the scroll counter (p.62).
6
Filter cover
Replacing the Filter Cartridge
Pull out the filter cartridge by holding the finger grip.
RECOMMENDATION
We recommend avoiding dusty/smoky environments when
operating the projector. Usage in these environments may
cause a poor image quality.
When using the projector under dusty or smoky conditions,
dust may accumulate on a lens, liquid crystal panels, or optical
elements inside the projector. Such condition may degrade the
quality of the projected image.
When the symptoms above are noticed, contact your authorized
dealer or service station for proper cleaning.
ORDER REPLACEMENT FILTER CARTRIDGE
Replacement filter cartridge can be ordered through your
dealer. When ordering, give the following information to the
dealer.
L Model No. of your projector
PLC-XTC50L
L Replacement Filter Cartridge
Type No. : POA-FIL-100
(Service Parts Code: 610 342 5764)
Connect the AC power cord to the projector and turn
on the projector.
7
Maintenance and Care
Filter cartridge
Downloaded From projector-manual.com Sanyo Manuals
To Next Page
Loading...
Need help?
General
