Sanyo PLC-XTC50L - Page 50

50
Capture
This function enables you to capture an image being
projected to use it for a starting-up display or interval of
presentations.
Select Capture and press the SELECT button.
A confirmation box appears and select [Yes] to capture the
projected image.
After capturing the projected image, go to the Logo select
function and set it to “User”. Then the captured image will
be displayed the next time you turn on the projector.
To cancel the Capture function, select [No].
Select [Yes] to capture
the projected image.
Select [Yes] to
stop capturing.
Capture
Notes:
 s"EFORECAPTURINGANIMAGESELECTh3TANDARDvIN
THE)MAGE-ENUTOCAPTUREAPROPERIMAGEP
 s!SIGNALFROMACOMPUTERCANBECAPTUREDUPTO
8'!X!SIGNALFROMVIDEOEQUIPMENT
CANBECAPTUREDEXCEPTFORPIANDI
 s7HENCAPTURINGTHEIMAGETHATHASBEENADJUSTED
BYTHE+EYSTONEFUNCTIONTHEADJUSTEDDATAIS
AUTOMATICALLYRESETANDTHEPROJECTORCAPTURESAN
IMAGEWITHOUTKEYSTONECORRECTION
 s7HENTHE,OGO0).CODELOCKFUNCTIONISSETTO
h/NvTHE#APTUREFUNCTIONCANNOTBESELECTED
 s7HENSTARTINGTOCAPTUREANEWIMAGETHE
PREVIOUSLYSTOREDIMAGEISCLEAREDEVENIFYOU
CANCELTHECAPTURING
 sh5SERvCANNOTBESELECTEDWHENTHEIMAGEISNOT
CAPTURED
Setting
This function prevents an unauthorized person from
changing the screen logo.
Off ........... The screen logo can be changed freely from
the Logo Menu (p.51).
On ............ The screen logo cannot be changed without
a Logo PIN code.
If you want to change the Logo PIN code lock setting,
press the SELECT button and the Logo PIN code dialog
box appears. Enter a Logo PIN code by following the
steps below. The initial Logo PIN code is set to “4321” at
the factory.
Logo PIN code lock
Logo PIN code lock
Downloaded From projector-manual.com Sanyo Manuals