Setting of output destination and conversion mode
When clicking Change button on the confirmation
window in the step 3 on the previous page, following
option setting window appears.
Output destination
Select either Folder or FTP server as the output
destination of the converted files.
Folder
Output folder .......... Specify a folder in the local hard disk or
shared computer in the network
FTP server
Host name ................ Enter host name or IP address of the FTP
server
Root Folder .............. Specify the root directory of the FTP server.
Normally use "/".
User ID ....................... Enter your login account of the FTP sever.
Password................... Enter your password of the FTP server.
Output folder .......... Specify a directory of the FTP server.
Conversion mode
Resolution ................ Selects output image resolution (VGA to SXGA+)
✐
The image resolution higher than the projector's panel resolution cannot be displayed.
Image rotation
..........
Selects image rotation (0, 90, 180, 270).
Conversion Type
Fit ............................... Converts either width or height of the image to fix the maximum screen width or height.
Justify
[both ends] .................. Converts width of the image to fix the
maximum screen width.
Justify
[top and bottom] .......... Converts height of the image to fix the
maximum screen height.
Cut ............................ Cuts image with the screen size not
depending on the image size for the
cutting modes. See the right figure.
✐ Select this mode when you want to have
the images with the original size. Select
each mode by clicking on the button.
Image Quality .........Selects an image conversion quality with "High", "Mid" or "Low".
Creating the available data [Network Viewer 5]
To Next Page
Loading...
Need help?
General