How to set the timer
1 Set a day or date
To set the timer event at the same time everyday or every week,
Select day entry with radio button and then select desired day from the pull-down menu button.
The selectable days are as follows:
- Same time everyday - Every week (days from Monday to Sunday)
To set the timer event on specified date,
select date entry with radio button and then type the date with (Year/Month/Date) format.
Ex.: Type [2007/12/20] if you specify [December 20, 2007].
Timer setting
This page is to set the timer to turn the projector off or on at a programmed day/date
and time. Follow the steps below for setting.
Click Timer on the main menu.
Present time set on the
projector
Select date
Select day
Set execute time
Event
action
This projector does not provide the built-in battery. The date and time information are lost when
the projector turns off (when "Eco" is set for the stand-by mode (Refer to p.72)), or the network
configuration is reset, or the input mode "Wired" or "Wireless" is turned. The timer function is disabled
until time is set up correctly. When using the NTP address for time setting, the current time is acquired
at the projector starting up and the timer function is activated after finishing the time setting
correctly.
"---" will appear on the cur-
rent time when the time is
not set up correctly.
To Next Page
Loading...
Need help?
General