Network information
The Network PIN code is to restrict the access from the networks to the projector.
After setting the Network PIN code, you need to enter it to operate the projector via the networks.
1. Select Network PIN code menu, and press SELECT button.
The Network PIN code screen will appear.
2. Set the Network PIN code.
Set the figures with the Point ed buttons and move to the next items with the Point 7 8 buttons.
Select “Set” and press SELECT button to set. To cancel the preset Network PIN code, select “Cancel”.
When you do not want to set the Network PIN code, set "0000".
It is recommended to set the Network PIN code if you use the projector via the networks. The Network
PIN code can be set also through the networks. See “6. Basic setting and operation” ➔ “Initial setting” ➔
“Network PIN code setting” (p49).
Wired factory default
Select Network information from the projector menu and press SELECT button to show LAN setting
environment of the currently selected projector. (The description below is an example and different
from what will be shown.)
Select “Wired factory default” from the projector menu and press SELECT button. All the wired LAN
settings will go back to the factory default settings. For details, refer to “Wired LAN factory default settings”
(p.31).
Wired factory default
Network information
Network PIN code
(See the menu above.)
(See the menu above.)
Network PIN code
Network PIN code screen
Network information
MAIN PROGRAM: V1.000
MAC ADDRESS: 08007B650056
IP ADDRESS: 172.21.95.202
To Next Page
Loading...
Need help?
General