✐ In the automatic displaying mode [Auto], when the left-click on the remote control is pressed, automatic displaying
stops and the manual displaying mode is set. When the right-click is pressed, automatic displaying restarts.
✐ The image data used for this function is the program or folder that the Network Viewer function used last time. The
projector cannot specify particular images or file servers itself.
✐ The display time is greatly affected by the network environment or the operation of multi control, so the image
display may not be displayed as it is set for the specified display time.
2 Select "Auto" or "Manual" and then press SELECT button. When selecting "Auto", Set display time and
repeat times
3 Select "Connect" and then press SELECT button to start displaying. The images in the FTP server are
displayed on the screen.
✐
It enables you to browse the images by using the control buttons (s,t) on the remote control or on the
projector.
s : Previous image display, t : Next image display
4 To stop the display, select "Disconnect" and then press SELECT button.
Item Description
Auto ............................ Auto display mode. Specifies display periods and repeating times
Sec. ........Display time of the image (3 to 240 sec.)
Times ......repeat times (255 times maximum) *
∞ means endless play
Manual.......................
Manual display mode. Controls image display (browsing image backward or forward) manually.
Using the network viewer function
Display time
Repeat times
To Next Page
Loading...
Need help?
General